Kontron VMP1 with Netbootloader - Manual (Page 33)

VMP1 Functional Description
ID 26037, Rev. 01 Page 2 - 11 ® 2002 PEP Modular Computers GmbH
2.4.3.2 Ethernet Connector and Pinout
The Ethernet interface is based on a PCI device
from Intel; the Ethernet Controller 82559ERS.
The main features of the Ethernet are as follows:
• integrated IEEE 802.3 10Base T and 100Base TX compatible PHY
• glueless 32-bit PCI master interface
• compatible with driver software of the 82558 and 82557
• full duplex support at both 10 and 100 Mbps
• IEEE 802.3u Auto-Negotiation support
• 4 kB transmit and 3 kB receive FIFO’s
Ethernet Connector Pinout
The connector used for the 100BaseTX Ethernet interface is an RJ45 connector.
The signals on this connector are as follows
Table 2-2: Ethernet RJ45 Pin Assignment
Pin Number Signal
1 TX+
2 TX-
3 RX+
4 nc
5 nc
6 RX-
7 nc
8 nc
1
8