Kontron CP384 - Manual (Page 21)

ID 31440, Rev. 01 Kontron Modular Computers GmbH
P R E L I M I N A R Y
Rev
N
r. = CP384 -
31440_
01 - 060
503/
144
227
Page 1 - 5
Introduction CP384
The following table provides a quick overview of the CP384 board.
1.3 Board Overview
1.3.1 Board Introduction
The CP384 is a digital input and digital output board which provides 24 channels grouped into
one digital input cluster consisting of 16 channels and one digital output clusters consisting of
8 channels.
Table 1-1: CP384 Product Overview
CP384 FEATURES DESCRIPTION
Digital Input and Output
Board • CompactPCI: 3U, 4HP
• 33 MHz system clock
• 32-bit address and data bus
• Designed for Plug and Play
• Complies with the CPCI specification
Digital Input Channel • Input Signals: Voltage range:low: -3V to +5V
high: +11V to +30 V (+24V standard)
Maximum current: 5 mA
• Channel Isolation: The input channels are isolated from the system side and do
not share common GND or VCC.
• Output Data: A maximum of 16 measured digital values
Interrupt messages (optional)
Programmable registers (read / write, compare, event and
latch)
• Debouncing: Range of settings available: 33 MHz, 128 kHz, 32 kHz, 8 kHz,
2 kHz, 500 Hz, 125 Hz, 31 Hz (30 ns default)
Digital Output Channels One cluster of 8 channels of relay switched digital outputs
Each channel has its own set of single pole, double throw relay contacts: common,
normally open, and normally closed.
The cluster permits only one supply voltage (24V ± 20%) for the relay coils. The
relay contacts may be supplied with different voltages within the allowable range.
The output channels are galvanically isolated from the system side and from each
other within the CP384.
External Interfaces 2 external interfaces: the digital input and output interface connector (CON2) on the
front panel and a single CompactPCI connector (CON1( J1)) at the rear.
The digital input and output interface connector supports up to 16 digital input and 8
3-pin digital output channels. The connector pins are subdivided into 2 clusters or
groups.
The CompactPCI connector is the standard CPCI type connector for CON1.
Indicators One green LED (Run) and one red LED (Fail) which are user configurable
Temperature Range The board is qualified to operate over a wide range of temperatures as follows:
• Operational:
0ºC to +60ºC Standard
-40ºC to +85ºC E2
• Storage: -40ºC to +115ºC