Jeep 2015 Wrangler - Uconnect 730N Manual - Manual (Page 47)

sky. If the screen shows Acquiring Signal, you might have
to change the vehicle’s position in order to receive a
signal. In most cases, the satellite radio does not receive
a signal in underground parking garages or tunnels.
Change A Channel Or Frequency
Push the SEEK up or the SEEK down button on the
faceplate to play the next available station or channel.
Select DIRECT TUNE button on the touchscreen to enter
a frequency or a channel number and confirm your
selection by pressing the GO button on the touchscreen.
Press the “Left Arrow” button on the touch-
screen to step down manually through the
frequency or channel roster.
Press the “Right Arrow” button on the touch-
screen to step up manually through the fre-
quency or channel roster.
Select the SCAN button on the touchscreen for a five
second preview of each listenable station in the frequency
band. Press the SCAN button on the touchscreen again to
stop the scan function and to select a radio station.
Replay Mode
Select the REPLAY button on the touchscreen for a replay
of the currently playing satellite radio station.
Use the left and right arrow buttons on the touchscreen to
move the red replay slider. Depending on broadcast
format, it is possible to replay up to one hour.
It is also possible to use the PAUSE/PLAY button on the
touchscreen to pause the playback for up to an hour.
Select the LIVE button on the touchscreen to receive the
currently playing satellite radio station.
36 Uconnect® MULTIMEDIA (RADIO)