Jeep 2015 Wrangler - Uconnect 730N Manual - Manual (Page 23)

NOTE:
If the ignition is switched OFF with the radio in
standby mode, the radio memorizes the standby state
when the ignition is switched ON again. Push the (4)
ON/OFF VOLUME rotary knob to switch the radio ON.
The navigation software is always working when the
ignition is switched ON, even if the radio is in standby
mode. It is possible to eject the CD and to display the
time if the unit is switched off.
5 — Voice Command
Push the Voice Command button on the
faceplate (5) and wait for the confirmation beep
before you say a voice command.
NOTE:
Some vehicles may be equipped with a Voice Com-
mand button on the steering wheel.
(6) Uconnect® Phone
Push the Uconnect® Phone button on the
faceplate (6) to either activate the Uconnect®
Phone system or to cancel an active phone call.
NOTE:
Some vehicles may be equipped with a Uconnect®
Phone button on the steering wheel.
7 — MENU
Push the MENU button on the faceplate (7) to access the
system settings menu.
NOTE:
Push the MENU button on the faceplate in an active
mode to change mode specific settings.
12 GENERAL HANDLING