Habey PRO-6820 - Manual (Page 10)

Safety Instruction
Electrical Safety
• If the power supply is broken, do not try to fix it yourself. Contact a qualified
service technician or your retailer.
• When adding or removing devices to or from the system, ensure that the
power cables for the devices are unplugged before the signal cables are con-
nected. If possible, disconnect all power cables from the existing system be-
fore you add a device.
• To prevent electrical shock hazard, disconnect the power cable from the
electrical outlet before relocating the system.
• Before connecting or removing signal cables from the motherboard, please
ensure that all power cables are unplugged.
• Do not damage the power cord nor place heavy objects on it, stretch it or
over bend it. Damage to the cord may result in or electric shock.
• Make sure that your power supply is set to the correct voltage in your area.
Incorrect voltage may cause personal injuries and damage the system.
Operation Safety
• Before installing the motherboard and adding devices on it, carefully read all
the guides that came with the package.
• To avoid short circuits, keep paper clips, screws, staples, and any other small
metal objects away from connectors, slots, sockets and circuitry.
• Do not use the system where there is a lot of dust, humidity is high, or
where the system may come into contact with oil or steam, as this could lead
to fire.
• Ensure that the system does not come into contact with water or other
fluids. Ensure that no objects such as paper clips or pins enter the system as
this could lead to electric shock.
• Do not place the system in unsafe places. Do not allow the system to re-
ceive strong shocks or to strongly vibrate. This may cause the system to fall
or topple over damaging the system.
• Do not use the system near heating equipment or in places where there
is likelihood of high temperature, as this may lead to excessive heat and
outbreak of fire.
• Do not use the system in places where it may be exposed to direct sunlight.
The product specification and pictures are subject to change without prior
notice!
5