ETS-Lindgren 4340 Digital Camera System (CCTV) (Archived) - Manual (Page 41)

Install Optional Components | 41
3. Place the camera and camera
enclosure in a stable location
to prevent it from rolling or
falling. Securely support the
camera and enclosure, and
rotate the 3/8-in thread
center pole into the threaded
connector on the bottom of the
enclosure.
4. Supporting the camera and enclosure, carefully re-insert the 3/8-in thread
center pole into the tripod. When the center pole is at the desired height, rotate
the height adjuster knob to tighten.
5. Place the fiber optic-to-Ethernet converter in the same location as the personal
computer.
6. Connect an Ethernet cable from the computer to the converter.
7. Connect two fiber optic cables to the converter and run the cables through the
feedthrough connectors to the location of the camera and tripod in the chamber.
If you have a shielded control room, you will run the cable through two sets of
feedthrough connectors to the camera and tripod.
8. Plug the fiber optic cables into the fiber optic connectors on the bottom of the
converter enclosure.
9. Place the battery pack on the chamber floor next to the tripod. Plug one end of
the power cable into the battery pack, and the other end into the power
connector on the bottom of the converter enclosure.
You must charge the battery pack before using it for the first time. See
Charging the Battery Pack on page 55 for complete charging
information.
Archived 6/3/13