ETS-Lindgren 4340 Digital Camera System (CCTV) (Archived) - Manual (Page 24)

24 | Pre-Installation Tasks
Choose the Camera Location
You will install the 10/100 Ethernet filter on the outside of the chamber at the
source of power, and the camera will mount to the filter penetration inside the
chamber. Verify that the view from the selected location is obstruction-free,
especially if absorber cones are in the vicinity.
A tripod-mounted camera receives power from the battery pack, so a
10/100 Ethernet filter is not provided.
The standard mounting hardware for the Model 4340 CCTV includes two 12-inch
pipe lengths, one 6-inch pipe length, one elbow joint (for wall mount only), and
four pipe-to-pipe couplers. When installing the camera in a chamber with
absorber cones, the camera enclosure should extend just past the tips of the
cones. These pipe lengths can be assembled in a variety of lengths to
accommodate most configuration requirements.
Archived 6/3/13