ETS-Lindgren 4340 Digital Camera System (CCTV) (Archived) - Manual (Page 27)

Install the 10/100 Ethernet Filter | 27
2. Clean DC power emerges from the filter module to the clean side of
the 10/100 Ethernet filter as two connectors:
 Power connector for camera —The power cable from the camera
plugs into this power connector.
 Power connector for Ethernet-to-fiber optic converter —This power
connector plugs into the converter. The Ethernet cable from the
camera also plugs into the converter.
3. Internal fiber optic cables extend from the external fiber optic
connectors on the dirty side of the 10/100 Ethernet filter to the clean
side. On the clean side, internal fiber optic cables plug into the
Ethernet-to-fiber optic converter. Depending on your configuration,
external fiber optic cables may plug into the external fiber optic
connectors.
Installing a Schuko Plug
If required by your country location, install a Schuko plug with the installation of
the 10/100 Ethernet filter.
1. Remove the access
cover.
Archived 6/3/13