ETS-Lindgren 2071B Antenna Positioning Tower (Archived) - Manual (Page 23)

Assembly Instructions | 23
5. Remove the mast locking pin and pivot the lower mast section down and
horizontal to the floor.
6. With the mast and lower mast section in horizontal position, insert the mast
into the lower mast section, aligning the pulley at the top of the mast with the
pulley on the motor.
7. Raise the mast and lower mast section to a vertical position and re-insert the
mast locking pin.
8. Connect fiber optic cables between the motor and the Model 2090 Series
Multi-Device Controller (or next generation ETS-Lindgren controller, if
applicable) and supply power to the controller and the motor.
The fiber optic cable must be looped through the P clip installed on the
front panel of the motor base. Failure to do so will increase the chance of the
fiber optic cable being accidentally pulled and breaking the fiber optic
connectors and/or causing damage to the cable.
If you have a hand-held controller, you may connect it at this time.
Archived 06/24/14