ETS-Lindgren 2071B Antenna Positioning Tower (Archived) - Manual (Page 11)

Introduction | 11
Standard Configuration
Feature
Model 2070B
(Non Bore Sight)
Model 2071B
(Bore Sight)
Variable Speed Motor,
220V Single Phase Input
Castered Platform for Portability
Single-Piece Mast for Rigidity
Fixed Boom with
Centerline Pneumatic Polarization
—
Bore Sight with
Centerline Pneumatic Polarization
—
Infrared (IR) Remote Controller
(see page 39)
10-Meter Fiber Optic Control Cable
Fiber Optic Shield Room Penetration Kit
routes the fiber optic control cable from the
control room to the shield room while
maintaining shielding attenuation. The
pieces are made of brass for conductivity
and provide attenuation of greater that
100 dB at 10 GHz. A single 25-mm
(1.0-in) hole is required for mounting.
Optional Items
M ODEL 2090 S ERIES M ULTI -D EVICE C ONTROLLER
The Model 2090 (or next generation ETS-Lindgren controller, if applicable) is a
separate component required for Model 2070B/2071B operation.
The Model 2090 requires firmware revision 3.12 or higher.
The Model 2090 Series Multi-Device Controller provides control for two separate
devices, such as ETS-Lindgren towers and turntables, plus the control of four
auxiliary devices through a fiber optic interface. The Model 2090 includes a
GPIB bus and is compatible with most popular EMI measurement software.
A DDITIONAL F IBER O PTIC C ABLE
Various lengths of fiber optic cable are available by custom order. The standard
length provided is 10 m (32.8 ft).
Archived 06/24/14