ETS-Lindgren 2071B Antenna Positioning Tower (Archived) - Manual (Page 17)

Electrical Installation | 17
4.0 Electrical Installation
Before installing any components, follow the safety information
in the ETS-Lindgren Product Information Bulletin included with
your shipment.
Electrical installation must be performed by a qualified
electrician, and in accordance with local and national electrical
standards.
Make sure the power is off and secured before proceeding.
Wire Gauge
Whenever possible the motor should be powered from a separate branch circuit
of adequate capacity to keep voltage drop to a minimum during startup and
running. For longer runs, increase the wire size in accordance with the following
wire selection guide.
Never use smaller than 14 AWG for any installation.
Length of Wire
@ 220 V: 0-15.24 m
(0-50 ft) 15.24-30.48 m
(50-100 ft) 30.48-60.96 m
(100-200 ft)
Wire Gauge
Required:
14 AWG 14 AWG 14 AWG
Archived 06/24/14