Dynojet 248x: DynoWare EX+ Upgrade - Manual (Page 14)

DynoWare EX+ Upgrade For The Model 248 Dynamometer
D Y N O W A R E E X + U P G R A D E
The DynoWare EX+ System
8
C ONNECTING Y OUR S HOP A IR TO THE D YNO
Dynojet recommends using an air filter/dryer. Failure to use clean, dry air will
compromise the integrity and life of the air components.
1
Mount the air pressure regulator on the wall in the shop with the bracket
provided.
2 Connect a supply air hose to the inlet of the regulator from your shop air supply.
The regulator should be set to 60 psi.
3 Connect the 3/8-inch air hose to the outlet side of the regulator and connect the
other end of the air hose to the barbed inlet fitting on the air control switch on
top of the right air canister on the dyno. Refer to Figure 7.
Note: Make sure the arrow on the regulator is the same as the direction of the air
flow.
W IRING THE D YNO W ARE EX+ M ODULES
1 Place the DynoWare EX+ modules in a safe location in the shop that is close
enough to the computer and the dyno for the cables to reach.
2 Attach the cables to the DynoWare EX+ modules. Refer to Figure 8 for cable
placement.
• Attach the 9-pin shielded serial cable from the PC to the RS-232 socket on the
CPU module. Tighten the screws. A 9-pin to 25-pin adapter may be required.
• Attach the 25-pin shielded cable from the dynamometer to the Dynamometer
Input/Output module. Tighten the screws.
• Attach the 9-pin connector from the hand-held pendant to the Dynamometer
Input/Output module. Tighten the screws.
• Attach the 3-pin plug from the power supply to the CPU module with the flat
side facing down.
3 Plug the power supply into an electrical outlet.
4 Turn the power switch on at the CPU module and verify operation with WinPEP.
Figure 8: Attach the DynoWare EX+ Cables
primary inductive
pickup socket
9-pin, hand-held
pendant
25-pin socket
9-pin, RS-232 socket
3-pin power plug
power LEDs
power switch