Dynojet 248x: DynoWare EX+ Upgrade - Manual (Page 11)

D Y N O W A R E E X + U P G R A D E
The DynoWare EX+ System
Version 2 DynoWare EX+ Upgrade For The Model 248 Dynamometer
5
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
THE DYNOWARE EX+ SYSTEM
The DynoWare EX+ system is comprised of four modules: the CPU Module, the
Dynamometer Input/Output Module, the RPM Module and the Atmospheric Sensing
Module. The upgrade requires a new Breakout board (the interface between the dyno
and the new DynoWare EX+ hardware). These modules need to be located where
they will be visible during a dyno run. It is recommended that they be mounted on a
shelf on the wall or on a cart along side the personal computer. This section will
provide you with the information necessary to install and connect the new
components.
Figure 4: DynoWare EX+ Modules
Figure 5: DynoWare EX+ Components
atmospheric
sensing module
RPM module
dynamometer
input/output module
CPU module
Breakout board mounting
bracket and hardware
Breakout board and
data acquisition cable
optical pickup card
DynoWare EX+ modules
wall mounting bracket
and hardware
secondary inductive
pickup cables
primary inductive
pickup cable
air pressure regulator, gauge,
and mounting bracket
air brake control
switch assembly
Breakout board to
DynoWare cable
DynoWare to
computer cable
power supply and
power cord