Dynojet 224: Pit Eddy Current Brake User Manual
Dynojet Equipment
Table of contents
Document Outline
- Cover
- Copyright
- Table of Contents
- 1 - Eddy Current Brake Installation
- Introduction
- Power Requirements and Installation
- Eddy Current Brake Installation
- Before Installing the Eddy Current Brake: Verify Optimal Brake Cooling
- Unpacking the Eddy Current Brake
- Installing the Bearing
- Installing the Spline Shaft and Driveline Assembly
- Installing the Eddy Current Brake
- Installing the Pit Cover Supports and Theta Controller
- Securing the Brake to the Dyno Pit Floor
- Routing the Brake Cables
- Wiring the Breakout Board
- Replacing the Theta Controller Fuses
- 2 - Torque Module Installation
- 3 - Basic Dynamometer Operation
- A - Red Head Anchor Installation
- B - Power Requirements-Excluding North America
- C - Installing the Adapter and Bearing-Early Model Dynos
- Template-Early Model Dynos
- Index