Dynojet 224: Pit Eddy Current Brake - Manual (Page 44)

Model 224 Pit Eddy Current Brake Installation and User Guide
C H A P T E R 3
Loading the Car
3-2
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
LOADING THE CAR
Use the following steps to load a car on the dyno.
1
Verify the dyno electronics power is on and connected to your computer.
2 Make sure you are in the MakeRun screen.
3 Set the dyno brake on by pressing the red button on the hand held pendant.
4 For four or all wheel drive vehicles, measure the wheel base on the vehicle and
adjust the 224-4WD dyno to the dimension before driving the vehicle on the
dyno.
5 Drive the vehicle onto the dyno and align the vehicle straight with the dyno.
6 Stop the vehicle when the drive axle(s) is centered on the drum(s).
Figure 3-1: Center the Drive Axle(s) on the Drum(s)
7 When the vehicle is positioned properly on the dyno, shut the engine off.
• If the vehicle has an automatic transmission, place it in park.
• If the vehicle has a manual transmission, place it in gear.
8 Set the vehicle’s emergency brake.
9 Secure the non-drive wheels using the provided tire chocks. Do not use tire
chocks for four wheel drive vehicles.
center drive axle on dyno drum
adjust wheel base of
224-4wd dyno
center drive axle on both dyno drums
rear or front wheel
drive vehicles
four or all wheel
drive vehicles