B&M 40505 BRACKET AND LEVER KIT, 4R100/E40D - Manual (Page 7)

STEP 20. Move the transmission selector lever all of the way
forward to the park position. Then move the lever rearward two
positions to the neutral position. Install the swivel on to end of
cable and adjust until the small end of swivel slides freely in and
out of the selector lever. Move the shifter through all of the gear
positions and check that the swivel slips freely in and out of the
selector lever in each gear position. Note: Swivel may have to be
adjusted one turn in either direction. Install cotter pin into swivel
and spread key ends.
STEP 21. Start the engine and shift the transmission through all
of the gear positions and then to neutral. Check the
transmission fl uid level, and add more fl uid if necessary
to bring it up to the proper level. Be sure that the
shifter operates smoothly and that the transmission
shifts to the correct gear.
STEP 22. INSTALL COMPLETE! ENJOY!
Technical service calls, correspondence, and warranty
questions should be directed to the following address:
B&M Racing and Performance Products
100 Stony Point Rd., Ste. 125
Santa Rosa, CA 95401
Phone (707) 544-4761
Monday-Friday 7AM to 5PM PST