B&M 40505 BRACKET AND LEVER KIT, 4R100/E40D - Manual (Page 6)

STEP 16. Fill transmission with proper amount
of transmission fl uid.
STEP 17. Remove two rubber boots, one large nut,
and a large lockwasher from threaded
end of shifter cable.
STEP 18. Route the cable from the shifter to the
transmission as explained in the shifter
installation instructions. Avoid sharp
bends and route the cable away from the
hot engine exhaust parts. Cable may be
secured up and out of the way with nylon
cable ties.
STEP 19. Slide end of cable into cable
bracket, install lockwasher and large
nut over end of cable. Tighten both large
nuts to hold cable in this position. Install
two rubber boots onto end of cable.