B&M 30228 TRANSPAK - Manual (Page 5)

For "S" link model manual valve only (See Fig. 4): Rotate
the range selector inner lever noting clearance with bolt 'A'
(See Fig. 9). If range selector inner lever contacts bolt 'A'
head or there is not a 1/16" clearance between the two,
mark that area of bolt head. Remove bolt & grind or file
angle flat at that portion of bolt head. Reinstall bolt &
check clearance again. Failure to provide clearance may
keep transmission shifter from fully shifting or locking up
between drive & 2nd.
STEP 15. Remove center pan bolt. Guide valve body into
position. Engage manual valve linkage in selector lever.
The "S" link can only be installed one way. Offset linkage
must be installed with the link in the forward position.
(See Fig. 4). Install valve body bolts finger tight. Install
detent roller spring so it engages range selector inner
lever. Tighten valve body bolts to 100 in. lbs. Make sure
range selector inner lever operates freely at this point with
positive indexing in each gear. "S linkage model"
manual valve only (See Fig. 4): Rotate range selector
inner lever all the way forward and check to see that bolt
'B' does not prevent range selector inner lever from going
into last detent slot. (See Fig. 9).
Figure 6
Figure 7
If bolt head 'B' prevents this action; rotate range selector
inner lever out of the way. Remove bolt and grind or file
a small amount off top of bolt head 'B'. Reinstall bolt 'B'
and check again. Failure to provide detent roller engage-
ment into range selector inner lever may result in trans-
mission not shifting into park.
Heavy Duty: Drill a 3/16" hole in the B&M plate in this location, using
your stock plate as a guide. Use a drill supplied with the kit.
Spring
retainer
Servo return
spring
Servo
apply rod
Washer
Intermediate
servo piston
Metal seal
ring
Figure 7A
Location two
Location one
Location three
Front servo
Location three and four
Remove checkball and do not reinstall
Location four
Figure 8
Figure 9
Stock spacer
support plate
Oil transfer
plate (gold)
Middle Support
plate (silver)
Range
selector
inner
sleeve
S-link
B
A