AVer IWH3216 Touch3216 Touch II user manual - Manual (Page 135)

129
voice.
5. In (4) Sensor, select and click on the sensor number (use  and  to select the sensor) to set the
condition for the system to alarm. If the sensor normal status is high, set the sensor condition to low.
- Continue trigger duration: Set a time period that when sensor has been trigger and stay in the
same status for that period, then the alarm will be sent out.
- Abnormal Event: Enable/disable to set the condition of the event for system to alarm..
 System Reboot: when the DVR system reboot without abnormal condition, the system will send
out the alarm message.
 Abnormal Reboot: when the DVR system reboot in irregular condition, the system will send out
the alarm message.
 Recording is switched off: when the recording has been stopped, the system will send out the
alarm message.
 Network is switched off: when the network connection of DVR system is lost, the system will
send out the alarm message.
 Hard Disk failed: when the hard disk can’t work normally, the system will send out the alarm
message.
- POS Keyword: Enable/disable to scan the data from the POS if it matches the keyword.
- Alarm Message: To active with external alarm message by your own program. For the detail
configuration, please contact the local reseller.
- Alarm Button: Enable/disable to active manual alarm function (see also Chapter 2.2#(19)). To define
alarm message of manually alarm trigger. Click alarm button and select the alarm button # and fill in
the description of alarm button.