AVer IWH3216 Touch3216 Touch II user manual - Manual (Page 10)

4
1.3 Hardware Introduction
1.3.1 Front Panel
1.3.1.1 IWH3216 Touch
TIP
Touch the blue word, button center, blue arrow, and blue area to make a selection or functional .
Name Function
(1) Power ON/OFF DVR unit
(2) IR Sensor Receive signal from the remote control to operate the DVR unit
(3) IR Sensor port For extended IR sensor cable(optional)
(4) System power indicator
System power status indicators. Indicate running state of system. Lights when the
system is running.
(5) HDD indicator When DVR system is recording, the light will keep flashing.
(6)
Move cursor to left, right, up, and down direction DVR application
interface and function setup window.
To move PTZ camera lens to left, right, up and down in PTZ mode
Touch the blue area to go to next or previous frame.
Go forward direction is Next frame and backward direction is
Previous frame.
(7) Confirm or make a selection
(8) Playback Control
buttons
To playback video at slower speed of 1/2x, 1/4x, 1/6x, 1/8x, 1/16x, or 1/32x.
To rewind the recorded video
To pause playback
To start playback
To playback video at faster speed of 2x, 4x, 6x, 8x, 16x, or 32x.
(9) Mode
Switch between preview, playback, and EMap mode.

In preview mode, user can switch between Preview, Playback and EMap mode.
 In playback mode, user can switch between Preview and Playback mode.
 In EMap mode, user can switch between Preview and Emap mode.