Turn on the power switch – Canon Speedlite 430EX User Manual
Page 10
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Turn on the Power Switch
1
Set the power switch to
^ The flash will start recycling.
Check that the flash is ready.
• When the pilot lamp lights in red, the
flash is ready to fire.
• To fire a test flash, press the pilot
lamp.
About Auto Power Off
To save battery power, the power will turn off automatically after 90 sec.
of idle use. To turn on the Speedlite again, press the shutter button
halfway. Or press the Speedlite's test firing button.
A test firing cannot be fired while the camera's operation timer 64 or (2)6
is active.
The Speedlite's settings will be retained in memory even after the power
is turned off. To retain the Speedlite's settings when you replace the
batteries, replace the batteries within 1 minute after turning off the power.
10