Nikon os Speedlight SB-102 - Manual (Page 9)

Replace the C-type
■ battery cartridge in
the battery chamber.
Be sure the speedlight power switch
® is in the “OFF” position, then
align the groove on the battery car­
tridge with the notch on the inside
of the compartment and slide the
battery cartridge into the chamber.
Replace the battery
" chamber cap.
While holding the buckles away
from the battery chamber cap,
align the battery chamber cap
index @ with the index on the speed-
light case and replace the battery
chamber cap.
Check the 0-ring: Before replacing
the battery chamber cap, examine
its 0-ring for dust and scratches
and be sure it is properly seated
and lubricated.
Lock the buckles.
" Push the battery chamber cap
against the speedlight case so it is
fully seated, hook the silver buckle
catches onto the pins on the speed-
light case, and pull the buckles In­
ward and upward until they lock
into position,
• W hen locking the buckles, be sure the silver
buckle catches are hooked onto the pins on
the speedlight case.
A Lock the buckle lock/
■ release latches.
Push the buckle lock/release
latches over the edges of the
buckles to lock them.
Loosen the joint
" knob ®.
To loosen the joint knob, turn it
counterclockwise while holding the
joint plate (g).
Properly position the
■ joint plate.
Turn the joint knob so the flat sides
of the joint plate are parallel with
the flat edges of the joint.