Loosen the arm ■ knob, Attach the bracket ■ @) to the arm, 2q^ remove the ■ camera’s flash sync socket cover – Nikon os Speedlight SB-102 User Manual
Page 11: Attach the camera ' body to the bracket
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Loosen the arm
■ knob®.
Turn the arm knob counterclock
wise as far as it will go to loosen it
(the two bracket positioning pins
on the bottom of the grip (g) will
be visible).
Attach the bracket
■ @) to the arm.
Slide the open end of the bracket
between the arm knob and the grip,
seat the two bracket positioning
pins in the two indentations on the
bracket, and turn the arm knob
clockwise as far as it will go to lock
the bracket into position.
•
The correct arm/bracket position is with the
three
washers
on
the
underside
of
the
bracket, the rubber side of the bracket facing
up,
and
flat
side
of
the
grip
perpendicular
to the bracket.
19.
Attach the cord
■ fastening hanger <
to the bracket.
As shown in the photo, slide
cord fastening hanger onto
bracket.
the
the
2Q^ Remove the
■ camera’s flash sync
socket cover.
Turn the camera’s sync socket
cover counterclockwise with a coin
to remove it.
21
.
Attach the camera
' body to the bracket.
With the camera against the rubber
side of the bracket and the camera’s
tripod socket over the bracket
screw, screw the bracket screw
into the camera’s tripod socket
until the camera and bracket are
securely attached.
Nikonos-V or Nikonos IV-A
11