Craftsman 315.228310 - Manual (Page 9)

UNPACKING
Your new table saw has been designed to give you
many years of high quaiity performance. To insure
this goal, proper care and treatment is important.
Careful treatment begins with removing all parts from
the carton and checking them against the list of loose
parts. The long box contains the rails. The large box
holds all other parts, which are detailed in the Loose
Parts List.
■ Separate the saw and all parts from the packing
materials and check each against the packing list,
especially the small parts that can be hidden in the
packing material.
Note: Do not discard the packing materials until you
have carefully inspected the saw, identified all
parts, and satisfactorily operated your new saw.
WARNING: Never use gasoline, naptha, or
other highly volatile solvents. Do not ever let
brake fluids, gasoline, pefroleum-based
products, or penetrating oils contact plastic parts.
Such chemicals can weaken or destroy plastic.
Remove the wax paper covering on the table. Use
any ordinary household type grease and spot
remover. Immediately apply a coat of automotive
type paste wax to the table and table exensions.
^ WARNING: To prevent accidental starting that
could cause possible serious personal injury,
assemble all parts to your saw before connecting
it to power supply. Saw should never be
connected to power supply when you are
assembling parts, making adjustments, installing
or removing blades, or when not in use.
^ WARNING: If any parts are missing, do not
operate this tool until the missing parts are
replaced. Failure to do so could result in possible
serious personal injury.
ACCESSORIES
The following recommended accessories are currently available at Sears Retail Stores.
Fence Guide System . .,. a , . .
' • 7 in. Stack Steel Dado
Guide Master
Box Joint & Miter Guide
Universal Jig
Taper Jig
10 in. Sanding Disc
8 in. Sanding Disc
Elite Dado
Excalibur Dado
7 in. Adj. Dado 36 tip
7 in. Adj. Dado 24 tip
7 in. X 9/16 in. Stack Dado
7 in. Molding Head Set
2 Bit Molding Head Set
Saw Baskets
Jointer Clamps
Specialty Throat Plate
Miter Gage Hold Down Clamp
Align-A-Rip XRC Rip Fence
Dust Collection System
A WARNING: The use of attachments or accessories not listed might be hazardous.
CRRFTSMRN* TABLE SAW 315.228310