Tools needed – Craftsman 315.228310 User Manual
Page 13
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
TOOLS NEEDED
The following tools are needed for assembly and alignment. Note: The five hex keys listed below have been
provided with your saw. The remaining tools are typical shop tools and are not included with your saw.
SMALL/MEDIUM
PHILUPS SCREWDRIVER
NUT DRIVER
8 mm, 10 mm, and 12 mm
Fig. 3
CRRFTSMHN* TABLE SAW 315.228310
See also other documents in the category Craftsman Power saws:
- TS3650 (8 pages)
- 113.24181 (40 pages)
- 572.24700 (6 pages)
- 137.21194 (44 pages)
- 118.22000 (15 pages)
- 137.21807 (56 pages)
- 113.244513 (20 pages)
- 315.24234 (42 pages)
- 509347 (48 pages)
- 351.21833 (12 pages)
- 113.298761 (56 pages)
- 137.248830 (31 pages)
- 113.2472T0 (40 pages)
- 286.17589 (48 pages)
- 137.218030 (30 pages)
- 137.21602 (36 pages)
- 509399 (52 pages)
- 137.21236 (29 pages)
- 137.21239 (50 pages)
- CONTRACTOR 351.21833 (36 pages)
- 286.25574 (48 pages)
- 286.26829 (46 pages)
- 315.220381 (82 pages)
- 113.248510 (52 pages)
- 315.235380 (38 pages)
- 315.228110 (54 pages)
- 315.212220 (39 pages)
- 137.212290 (28 pages)
- 917.27103 (60 pages)
- 315.216360 (26 pages)
- 172.267700 (18 pages)
- 315.108330 (20 pages)
- 315.108990 (20 pages)
- 315.212080 (36 pages)
- 315.212100 (38 pages)
- 315.212100 (4 pages)
- 315.212110 (38 pages)
- 315.212120 (36 pages)
- 315.212130 (36 pages)
- 315.214490 (32 pages)
- 315.214500 (34 pages)
- 315.214770 (32 pages)
- 315.228390 (66 pages)
- 315.228410 (8 pages)