Craftsman 315.228310 - Manual (Page 25)

ASSEMBLY
WARNING: If the blade is not fully lowered, turn
the height handwheel to lower the blade to
prevent injury.
■ Locate the blade guard, the blade guard bracket,
and the following hardware:
2 hex bolts (5/16-18 x 1/2 in.)
2 lock washers (5/16 in.)
3 socket head screws (1/4-20 x 3/8 in.)
3 flat washers (1/4 in.)
■ Align the lower end of the blade guard bracket and
the threaded holes of the cradle and insert the hex
bolts and lock washers. Securely tighten w№i a 12
mm wrench.
■ Remove the throat plate. See page 32.
■ Put the blade guard assembly in place on the table
top, aligning the screw holes in the riving knife to
the holes in the bracket. Align the hole In the front
of the riving knife base with the screw hole in the
saw table.
Note: The screw hole is located under the slot in back
of the throat plate.
■ insert two socket head screws and two flat washers
in the two holes at the back of the riving knife base.
Securely tighten with a 5 mm hex key.
■ Insert the third socket head screw and flat washer
into screw hole in saw table under throat plate.
Securely tighten with a 5 mm hex key.
■ Replace die throat plate.
INSTALLING THE BLADE GUARD
See Figures 23 - 25.
CttfIFTSMRN' TABLE SAW 315.228310