Craftsman 315.228310 - Manual (Page 22)

ASSEMBLY
■ Get the front rail, the switch assembly, and the
following hardware:
6 square head bolts (5/16-18 x 1 in.)
6 flat washers (5/16 in.)
6 hex nuts (5/16-18)
2 screws (1/4-20 x 3/8 in.) (located on switch plate)
2 square nuts (1/4-20) (located on switch plate)
Right and left end caps for front rail
2 screws (5/32-32 x 1/2 in.)
■ Set aside end caps and screws until you have
aligned the rip fence and front rail.
■ Insert the six square head bolts into the table and
extensions, so the bolt heads extend outward 1/2
in.
■ Loosely attach a washer and a hex nut to each bolt.
■ The back of the rail has two slots. Slide the upper
slot over the bolts. (Bottom slot Is for switch.)
■ Align the rail left to right - Match the 7-1/8 in. mark
on the right scale to the right edge of the table saw
base (main table). See Figure 16.
■ Snug the rail against table. Finger-tighten each nut
on Uie table and extensions.
■ Locate the switch assembly. The two screws are
installed through the back of the switch plate with
the square nuts extending out toward the front.
Note: The square nuts are loose on the switch plate.
■ Slide the square nuts into the lower slot of the rail.
■ Slide the switch assembly to a convenient position,
leaving ample clearance for the handwheel. Tighten
securely with a screwdriver. Do not tighten the rail
bolts.
^ WARNING: Place the switch out of the
immediate work area to avoid accidentally
turning it off during operation.
INSTALLING THE FRONT RAIL
See Figures 15 and 16.
TABLE
SQUARE
HEAD BOLTS
TABLE
EXTENSION
Fig. 15
FRONT RAIL
END CAP
7-1Ain.MARK
RIGHT SCALE
ClIRFTSMIlir TABLE SAW 315.228310
Fig. 16