Craftsman 139.53675SRT - Manual (Page 33)

Receiver and Remote Control Programming
SE€URnT+
Your garage door opener receiver and remote control
have been pre-set at the factory. The door will open
when you press the LARGE remote control push
button. The code between the remote control and the
receiver changes with each use, randomly accessing
over 100 billion new oades.
The 3-function remote control can also activate
additional SECURITY*®» garage door openers and/or
light controls.
Your SECURrTY-f opener will operate with:
• several SECURITY*® remote controls (with blue
push buttons) utilizing up to 8 functions.
• one SECURITY*® Keyless Entry System (Mode!
139.53684).
Follow the instructions beiow to program your opener
to match any additional remotes you may purchase.
See Accessories on page 38.
To Add A Remote Control
If you have a Premium Control Console:
1. With the door closed, press and hold a remote
Gontroi push button. See Rgure 1.
2. Press and hold the Light button on the door
control.
3. Press and hold the door control push button.
4. After the opener light flashes, release all buttons.
Test by pressing the remote push button.
If you do not have a Premium Control Console:
1. Press and /ю/d the selected remote control push
button. See Rgure 1.
2. Then press and release the SRT (leam) button on
the back panel of the opener, Rgure 2„ The
indicator light on ttie panel will begin to blink and
the opener light will ffash
once.
3. Release the remote push button.
Test by pressing the remote push button.
To Erase All Remote Control Codes
Press and hold the SRT button on the opener panel
until the indicator light turns off (about 6 seconds). All
remote control codes are now erased. Then follow
the steps above to re-program each remote control.
To comfW with FCC nites, ac^usttnent or m«£iicau'ahs of this recoiver
andior JransmitSef ara po5ii33fted, except for diangasg trio ccda seUitKi «
replacing tha taSety,
THEHE ABE NO OmSB USER SERVICEABLE
PARTS.
Children operating or playing with a garage
door opener can injure tftemseives or others.
The garage door could dose and cause serious
Injury or death. Do not allow children to operate
the door push button(s) or remote control's).
A moving garage door could Injure or kill
someone
under It Activate the opener only
when you can see the door clearly, it is free of
obstructions, and Is properly adjusted.
Figure 1
Seteci a remoia ссп&Ы posh
btittan w operate openar
SECURlTY-i"
3-Function
Remote Control
Figure 2
SECURITY*®
Garage Door Opener
To Control the Opener Light (Premium Consoles)
With SECURfTY-® remote controls, a push button can
be programmed to operate the opener light without
opening tie door.
1. With the door dosed, press and bold the remote
button that you want to control the light.
2. Press and hold the Light button on the door
control.
3. Press and hold the Lock button on the door control.
4. After the opener light flashes, release ail buttons.
Test by pressing the remote push button. The opener
light should turn on or off but the door should not move.
33