Installation step 6, Instai! the premium control console – Craftsman 139.53675SRT User Manual
Page 18
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
![background image](/manuals/632073/18/background.png)
Installation Step 6
Instai! the Premium Control Console
Locate the door control within sight of the door
at a minimum height of 5 feet where small
children cannot reach, and away from all moving
parts of the door and door hardware.
The door control is typically attached directly to the
wall If installing into drywall, drill 5/32" holes and
use the anchors provided.
For pre-wired insiaJiaiions
(as In new home œnstrucîian), Console models
may be mounted to a standard single gang box
(Figure 2).
1 .Strip 1/4‘ of insulation from one end of the bell
wire and connect it to the two screw terminals on
the back of the door control: white to 2, and
white/red to 1.
2, Pry off cover along one side with a screwdriver
blade (see Figure 1). Fasten with 6ABx1-1/4‘ self
tapping screws (standard installation) or 6-32x1*
machine screws (pre-wired instaliation) as follows:
• Install bottom screw, allowing 1/8* to protrede
above wall surface.
• Position bottom of door control on screw head and
slide down to secure. Adjust screw for snug fit.
• Drill and install top screw with care to avoid
cracking plastic housing. Do
not overtighten.
•
Insert top tabs and snap on cover.
3.
(For standard installation)
Run ttie bell wire up the
Do not connect to live electncal wiring. Connect
only to 24 Volt low voltage wires. Connection to
live wires or higher voltage may cause serious
injury from shock, bum or electrocution.
Children operating or piaying with a garage
door opener can Injure themselves or others.
The garage door could close and
cause
serious injury or death.
instail the door control (or any additional push
buttons) out of the reach of children and away
from all moving parts of the door and door
hardware,
but
H*ere the
garage door is visible.
Do riot allow children to operate the push
button(s) or the remote control(s).
A moving garage door could.injure someone
under it
Activate the opener only when the
door is properly adjusted, you can see it
clearly, and there are no obstructions to door
travel.
Hardware Shown Actual Size
NMjilriiHIijiHIIïïro
SA0
X1-1M* Screw
CofTtroi Cansofe (std instailalk«)
nm
11
^
6-32 xT Screw
Contttsl Console (pre-wired)
insuiatect
Stapies
OiyWaltAnetiore
18