Craftsman 139.53675SRT - Manual (Page 32)

Operation of Your Opener
Activate the opener with any of the following:
• The Remote Control; Hold push button down until
the door starts to move,
" The Door Control; Hold push button down until
the door starts fn move w V-l WWI O LCiAi um ? i-W t f c\^ w VC 4«
« The Outdoor Key Switch or Keyless Entry: (See
Accessories)
When the opener is activated with the safety
reversing sensor installed and correctly aligned:
1. If open, the door will close. If closed, the door will
open,
2. If closing, the door will reverse.
3. If opening; the door will stop (allowing space for
entry and exit of pets and for fresh air).
4- If the door has been stopped in a partially open
position, it will close.
5. If obstaicted while closing, the doorwii! reveree.
6. If obstructed while opening, the doorwiit stop.
7. The garage door will reverse Irr the closing cycle
when the invisible beam is broken. If fully open,
the door will not close when the beam is broken.
"TTiD CDnCAf* hiSC nA rSuffOAf tn
AAOAlAA 111^ is-c#I i - oim «I I Itd.w i 11«# i L s I I IJ 1x5 xJLa/lu«I ill ix^ w$x5•
If the sensor is not Installed, or is not aligned
rniTArtiv fhA dnnf
rln<5A finrn pnv rpinnti^ luw t i wx i w 1x7 SJ \JxJi wYXJi t i 11 wl 1 c OJ IV I x#l 1
transmitter. You can close the door with the Door
Control, the Outdoor Key Switch, or Keyless Entry,
however, if you activate them
until down travel Is
complete. If you release them too soon, the door will
f/a t/yi j"gy <3 # *
The opener lights will blink for S seconds when the
safety reversing sensor causes the door to reverse.
The Opener Lights wii! turn on under the following
conditions: When the opener is initially plugged in;
when the power is inteirupted; when the opener is
activated. They will turn off automatically after 4"1/2
minutes or provide constant light when the Light
feature on the Premium Control Console is activated.
SECURITY+ models: Lights will also turn on when
someone walks through the open garage door. Bulb
size is 75 watts maximum.
Weak or broken springs could allow an open
door to fall (either rapidly or unexpectedly)t
resulting in serious in}ury, death or property
damage.
If possible, use the emergency
release rope and handle only when the door is
fully closed.
Release Arm
Tfoiley
Einefigency
Release Handle
Manual disconnect
position
To open the door
manually:
The door should be
fully closed If possible.
Pull down on the red
emergency release
handle and lift the door
manually. To
fpnnnnpcf thA rfnnr tn
the opener, press the
Door Control push
button.
Release Airn
The lockout feature
prevents the trolley from
reconnecting automatically., ¡ ^
Pull the emergency handle
down and back (toward the
opener). The door can then
be raised and lowered
manually as often as
FtAAoeciiaA/ Т а H ícíaaaíüaíi níívAÍoocli у» *w и1хэЦ1 iUcÍUt5
the Lockout Feature, pull
the emergency handle
straight down. The trolley
will reconnect on the next Lockout position
UP or Down operation.
Emergency
Balease Haridfe
(PüÜ Dovm & Back
Towards Opener)
Operation of trie Door
(SECURiTY’i* models: See additional
Press the lighted push button to open or close the
door.
Press again to reverse the door during the dosing
cycle or to stop the door while ifs opening.
Premium Console:
L/ghfFeatore- Press the large round Light button,
the opener lights are off, they will turn on. If the
opener lights are on, (even in the 4*1/2 minute
automatic cycle) they will turn off.
But if you use the Light button to turn the lights on
and then activate the opener, the lights will turn off
after 4-1/2 minutes,
The Light button will not control the opener lights
when the door is in motion.
If
Controls (see page 18)
programming features, next page,)
Premium Console (cont):
Lock Feature - The Lock feature is designed to
prevent operation of the door from remote controls.
However, the door will open and close from the Door
Control, the Outdoor Key Switch and the Keyless Entry
Accessories,
To Activate; Press and held the small round Lock
button for 2 seconds. The push button light will flash
as long as the Lock feature is on.
To turn off: Press and hold the Lock button again
for 2 seconds.The push button light will stop
flashing. The Lock feature wii! also turn off whenever
the "SRT" button on the opener pane! is activated.
32