Craftsman 315.220381 - Manual (Page 53)

OPERATION
NON.THROUGH CUTS
See Figure 49.
A WARNING: Unplug the saw while removing or
replacing the blade guard. Turn on the saw with
the switch on the arm to confirm the blade is not
receiving power.
■ Remove the blade and blade guard (see Assembly
section).
■ Place a support the same height as the saw table
nearby for the cut work. Lower the blade with the
elevating handwheel.
■ Make sure the wood is not touching the blade.
Insert the key and turn on the saw. Let the blade
build up to full spewed before contacting the work­
piece.
A WARNING: Always use pushblocks when
** making non-through rip cuts to avoid the risk of
serious injury. Never feed wood with your hands.
■ When the work is completed, press the switch off
and remove the key.
NON-THROUGHCUT
Fig. 49
Control Cut Settings
W ood
Type
Crosscut
Setting
Position
Feet
Minute
Hard A 0-6
Medium B 0-20
Soft
c
0-35
W ood
Type
iwel Crosse
Setting
Position
ut
Feet
Minute
All Types A 0-6
W ood Setting Feet
Type Position Minute
Hard A 0-6
B 0-20
1 Soft 1
c
0-35
1 com pound Crosscut 1
W ood Setting Feet
Type Position Minute
All Types A 0-6
S3 CRHPTSMIir RADIAL SAW 315.220381