Sony SLV-690HF - Manual (Page 7)

step 3
Hookups
Selecting the best hookup option
There are many ways in which your VCR can be hooked up. To hook up
your VCR so that it works best for you, first scan through the table below.
Then use the accompanying diagrams and procedures on the following
pages to set up your VCR.
If you have^ Use Refer to
TV that has audio/video inputs Audio/video (A/V) hookup, then
follow one of the hookups belorv.
Page 8
Antenna only, no cable TV Hookup 1 Pages 9 to 11
Cable box with many scrambled
channels Hookup 2 Pages 12 to 14
No cable box or cable box with only a
few scrambled channels Hookup 3 Pages 15 to 17
Cable box with onlya few scrambled
channels, using an A/B switch Hookup 4 Pages 18 to 20
After you've completed the connections, follow the instructions for setup.
During setup, if you need more details on the procedure described, page
numbers are provided where you can find complete, step-by-step
instructions.
After you've completed the setup, you're ready to use your VCR.
Procedures differ depending on the hookup you used. For an overview,
refer to "Quick reference to using the VCR" on the back cover.
Before you get started
• Turn off the power to all equipment.
• Do not connect the AC power cords until all of the connections are
completed.
• Be sure you make connections firmly. Loose connections may cause
picture distortion.
• If your TV doesn't match any of the examples provided, see your nearest
Sony dealer or qualified technician.
Caution
Connections between the VCR's VHF/UHF connector and the antenna terminals of
the TV receiver should be made only as shown in the following instructions. Failure to
do so may result in operation that violates the regulations of the Federal
Communications Commission regarding the use and operation of RF devices. Never
connect the output of the VCR to an antenna or make simultaneous tparallel) antenna
and VCR connections at the antenna terminals of vour recei\ er.
Getting Started 1 7