Operation, When recording on this vcr), Note – Sony SLV-690HF User Manual
Page 48
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Editing with another VCR (continued)
Operation
(when recording on this VCR)
Before you start editing
• Turn on your TV and set it to the
video channel.
• Press CH +/- to display "L" in the
display window.
• Press TAPE SPEED on the remote
commander to select the tape speed,
SP or EP.
-------- ,■ ....................... I------------- ^
a 1 J
1 1 1
P)
II PAUS E «REC
1
Insert a source tape with its safety tab removed into the other
(playback) VCR. Search for the point to start playback and set it to
playback pause.
2
Insert a tape with its safety tab in place into this (recording) VCR.
Search for the point to start recording and press II PAUSE.
3
Press
#
REC on this VCR and set it to recording pause.
4
To start editing, press the II PAUSE buttons on both VCRs at the same
time.
To stop editing
Press the ■ STOP buttons on both VCRs.
Note
• If you start recording following the procedure above, the VCR won't start recording
with the APC function. To record a tape with the APC function, press # REC again
during recording pause in step 3 so that the VCR analyzes the tape. Then when you
start recording in step 4, press II PAUSE immediately after the APC indicator stops
flashing. If you press II PAUSE before the APC indicator stops flashing, the APC
function is canceled.
48
I
Additional Operations