Sony CMT-EX22 - Manual (Page 26)

Troubleshooting (continued)
Tuner
Severe hum or noise (“TUNED” or
“STEREO” flashes in the display).
• Remove the FM antenna from the rear panel
and place the antenna outside the cabinet.
Adjust the antenna.
• The signal strength is too weak. Connect an
external antenna.
• Make sure the antenna is connected properly.
• The AM antenna wire is detached from the
stand.
A stereo FM program is not received in
stereo.
• Press STEREO/MONO so that “STEREO”
appears.
If Other problems not described
above occur, reset the system
as follows:
1 Unplug the AC power cord.
2 Hold down l/C!), then plug the AC power cord
into the wall outlet again.
The system is reset to the factory settings. All the
settings you made, such as the preset stations,
clock, and timer are cleared. You should set them
again.
Specifications
Amplifier section
For the U.S. model
AUDIO POWER SPECIFICATIONS
POWER OUTPUT AND TOTAL HARMONIC
DISTORTION:
With 4 ohm loads both channels driven, from 120 -
10,000 Hz; rated 12 watts per channel minimum RMS
power, with no more than 10% total harmonic
distortion from 250 milliwatts to rated output.
Canadian model:
Continuous RMS power output (Reference)
15 + 15 watts
(4 ohms at I kHz, 10% THD)
European model:
DIN power output (Rated)
1 2 + 1 2 watts
(4 ohms at 1 kHz, DIN)
Continuous RMS power output (Reference)
15 + 15 watts
(4 ohms at 1 kHz, 10% THD)
Music power output (Reference)
15 + 15 watts
Other models:
DIN power output (Rated)
12 + 12 watts
(4 ohms at 1 kHz, DIN, 240 V)
12 + 12 watts
(4 ohms at 1 kHz, DIN, 220 V)
Continuous RMS power output (Reference)
15 + 15 watts
(4 ohms at 1 kHz, 10% THD,
240 V)
15 + 15 watts
(4 ohms at 1 kHz, 10% THD,
220 V)
Inputs PC/TAPE IN: voltage 250 mV,
impedance 47 kilohms
Outputs PC/TAPE OUT: voltage 250 mV,
impedance 1 kilohms
CD DIGITAL OUT: Optical
PHONES (stereo minijack):
accepts headphones of 8 ohms or
more
26