Sony CMT-EX22 - Manual (Page 25)

If you have any problem using this system, use the
following checklist.
First, check that the AC power cord is connected
firmly and that the speakers are connected
correctly and firmly.
Should any problem persist, consult your nearest
Sony dealer.
General
There is no sound.
• Press VOL +.
• Make sure the headphones are not connected.
• Check the speaker connections.
There is severe hum or noise.
• A TV or VCR is placed too close to the
system. Move the system away from the TV
or VCR.
“0:00” (or “12:00AM”) flashes in the
display.
• A power failure occurred. Set the clock and
timer settings again.
The timer does not function.
• Set the clock correctly.
The remote does not function.
• There is an obstacle between the remote and
the system.
• The remote is not pointing in the direction of
the system’s sensor.
• The battery has run down. Replace the
battery.
• Do not place the system in locations where it
is near an electric inverter system.
Troubleshooting
CD Player
The CD cannot be read.
• The CD was not placed in the disc tray
properly. Place a CD vertically in the tray.
The CD will not eject.
• The CD has tape, stickers, or paste on it.
The CD will not play.
• The CD is dirty. Clean the CD with a
cleaning cloth.
• The face of the CD is scratched. Exchange the
CD.
• The CD is facing the wrong way.
• Moisture condensation has built up. Remove
the CD and leave the system turned on for
about 2 hours until the moisture evaporates.
Play does not start from the first track.
• The player is in program or shuffle play
mode. Press PLAY/TUNING MODE
repeatedly until “SHUF” and “PGM”
disappear.
OVER is displayed.
• By pressing ►►, the last track on the disc has
been exceeded. Press and hold (or press
repeatedly) or to return to a track
where playing can begin.
continued
>
a
a
Ml
f*
Ml o
3
3
o'
3
r*
M l o
3
25