Sony CMT-EX22 - Manual (Page 10)

Basic Operations
Playing a CD
To turn on the system, press l/(!).
1 Touch A to raise the disc tray.
2 Place a CD vertically in the tray.
With the label side front.
When you play a CD single
(8 cm CD), use the optional
adaptor.
3 Press ►'ll (or CD
Play starts.
on the remote).
To Do this
Stop play Press ■.
Pause Press ►'ll (or II on the
remote). Press again to
resume play.
Select a track Press /►►! repeatedly
until you find the desired
track.
Find a point in a
track Press and hold
during play, and release it at
the desired point.
Remove CD Touch
Adjust the volume Press VOL +/-.
Tips
• You can switch from another source to the CD
player and start playing a CD by pressing ►II (or
CD ► on the remote) (Automatic Source
Selection).
• If you press ►!! (or CD ► on the remote) while
the power is off, the power turns on and play starts
automatically (One Touch Play).
• If you touch ^ while the power is off, the power
turns on, the function switches to CD, then the disc
tray rises automatically.
• If you press a number button on the remote, the
track corresponding to the pressed number on the
disc starts playing (Track Direct Play).
• To listen through the headphones, connect the
headphones to the PHONES jack on the rear panel.
Notes
• Do not forcibly press the disc down with your
finger, as this may cause CD player trouble.
Furthermore, do not obstruct the ejecting CD. Be
sure to touch to lower the disc tray.
• Do not push strongly on ^ on the unit, as this may
damage the player.
• The disc tray will not operate if you touch ifc while
wearing gloves. Touch — with bare hands or press
— on the remote.
To lower the disc tray, touch ^ again.
10