Sony STR-D1011 - Manual (Page 5)

Precautions
I Chapter 1 Getting Started
Unpacking
On safety
• Operate the unit only on 120 V AC, 60 Hz.
• Should any solid object or liquid fall Into the cabinet,
unplug the unit and have It checked by qualified
personnel before operating it any further.
• Unplug the unit from the wall outlet-if it is not to be used
for an exfended period of time. To disconnect the cord,
pull it out by grasping the plug. Never pull the cord itself.
• One blade of the plug is wider than the other for the
purpose of safety and vi/iil fit into the power outlet only
one way. If you are unable to insert the plug fully into tlie
outlet, contact your dealer.
To prevent internal heat buildup in the unit,
place the unit in a location with adequate air circulation.
Do not install the unit:
• near heat sources such as radiators or air ducts.
• in a place subject to direct sunlight, excessive dust,
mechanical vibration or shock.
Do not place anything on top of the cabinet.
The top ventilation Iroles must be unobstructed for the
proper operation of the unit and to prolong the life of its
components.
Do not throw away the carton and packing material!
It will be an ideal container when transporting the system for
repair work, etc.
On operation
Before making program source.connections, be sure to turn
the power switch off and unplug the unit.
On cleaning the cabinet
Clean the cabinet, panel and controls vv/ith a soft cloth lightly
moistened with mild detergent solution. Do not use any type
of abrasive pad, scouring powder, or solvent such as
alcohol or benzine.
For the customers in the U.S.A.
For detailed safety precautions, see the "IMPORTANT
SAFEGUARDS" leaflet.
If you have any question or problem concerning your unit,
please consult your nearest Sony dealer.
Checking the Supplied Accessories
After unpacking, check that the following accessories are
present,
• FM wire antenna........................................................... (1)
• AM loop antenna ......................................-.................... (1)
• Remote commander......................................................(1)
• Sony batteries SUM-3 (NS)...........................................(2)
inserting the Batteries into the Remote
Commander
Before operating remote comimander, install the batteries as
shown.
To avoid damage caused by battery leakage and
corrosion
When tlie comiTiander will not be used for a long time,
remove the batteries.
Battery life
Normal operation can be expected about a halt year using
Sony SUM-3 (NS), and a year using Sony AM-3 (NW)
alkaline batteries.
When the batteries are run down, the remote commander
will not operate the unit, in this case, replace batteries with
new ones.
Selecting the AM Tuning Interval
The AM tuning interval is preset to 10 kHz. To use the
receiver where the frequency allocation system is based on
a 9 kHz interval, make the following adjustments.
1 Turn on the power and tune In any AM station.
2 Turn off the power,
3 Press the POWER button while pressing the INDEX
SELECTATUNING + button.
To reset the AM tuning interval, repeat the above steps.
Caution
When the interval is changed, all preset stations which you
have memorized will be erased. After changing the interval,
be sure to preset the stations again.
5