Sony STR-D1011 - Manual (Page 24)

Recording an Audio Source
Recording onto an Audio Tape Deck or DAT Deck Tape Dubbing
! V »a V-
Audio signals
1
Select the desired program with the FUNCTION
buttons.
For an FM/AM broadcast, tune in the desired station
Set the tape (DAT) deck in the recording mode.
Start playback of the selected program source.
Monitoring the recorded sound
If you have connected a 3-head tape deck to the TAPE 2
jacks, you can monitor the recording results. While
recording or dubbing, press TAPE 2 MONITOR so that the
TAPE 2 MONITOR indicator lights up. To listen to the source
sound again, press the button again so that the indicator
goes off.
O Audio signals
POWER ON
I
]
I
....: : : h ]
■ 0 i
(D “ o
9S>'
to TAPE 2 OUT
4 , 2
Tape deck 2
(for recording)
to TAPE 1
(or DAT) IN
Tape deck 1 or
DAT deck
(for playback)
1 , 4
1
Insert the recorded tape into tape deck 1 (or the
DAT deck).
2
Insert a blank tape into tape deck 2 and adjust the
recording level.
3
Press TAPE 1 or DAT to select the deck for
playback.
4
Start the playback of the tape (or the DAT) in tape
deck 1 (or the DAT deck), and set tape deck 2 in
the recording mode.
Dubbing will start.
Note on tape dubbing
Tape dubbing is possible only in the following directions:
From
(playback deck)
To
(Recording deck)
Tape deck
connected to
TAPE 1 IN Tape deck connected to TAPE 2 OUT
DAT deck connected to DAT OUT
DAT deck
connected to
DAT IN
Tape deck connected to TAPE 1 or 2
OUT
Press the FUNCTION buttons according to the playback
deck.
24