Trail Tech TTV SWITCHING TEMPERATURE METER KTM 732-S02 - Manual (Page 3)

010-ELV-163
KTM 690
TTV Upgrade Instructions
Tech Support: 360-687-4530
[email protected]
KTM 690
TTV UPGRADE INSTRUCTIONS
GUIDE ON RELEASING CONNECTOR PINS:
Step 4-A:
Step 4-B: While depressing the locking tab, separate
the two connectors. Try not to pull on the wires.
Step 4-C: Release
the terminals. Use
a thin tool (a jewelers
pick, razor blade, or
small screwdriver.)
Use the tool to flip up
the locking tab that
secures the terminals
inside the connector.
Gently pull on the
wire while holding
the lock tab up to
remove the wire from
the connector.
Step 4-E: Continue to step 5.
See Step 4 on Reverse Side of Page.
Use caution if
using a razor
blade.
Find the brown 2-pin
connector on the harness
that is connected to the
OEM thermal switch. Use a
screwdriver to push down
on the locking tab which
holds the male connector
to female connector.
Release the pins for the two wires and
remove them from the connector. Next
install the included two pin connector by
inserting the two wires into the connector.
Make sure to insert them all the way until
they click into the locked position.