Trail Tech WIRE HARNESS WITH PUSH BUTTON SWITCH 040-WH7A - Manual

DUAL LIGHT WIRING HARNESS
SUMMARY & BENEFITS:
This installation is applicable to Trail Tech light installation, as well as other 12V accessories.
• The provided ring terminals are intended for connection to a battery.
• The switch can be bypassed by plugging the two switch bullets together (the outputs of the harness will then always be on.)
BENEFITS:
• No cutting or splicing required. Adds clean wire harness to bike - directly from lights to battery with fuse and switch.
INCLUDED PARTS:
WIRING HARNESS
INSTALLATION:
STEP 1: Determine location for lights to be mounted, and for
switch to be installed.
STEP 2: REMOVE THE FUSE FROM THE WIRING
HARNESS. DISCONNECT THE NEGATIVE TERMINAL OF
THE BATTERY.
STEP 3: Route wiring harness to battery, switch, and light
locations. Verify wire lengths are long enough before installing
switch or lights.
STEP 4: Mount lights per instructions included with lights. If
installing an optional switch, mount the switch per instructions
included with switch.
010-ELV-107
040-WH7
Tech Support: 360-687-4530
[email protected]
Connect Lights
Connect Switch
Connect Battery
STEP 5: Connect wiring harness to lights. The black wires
should match, and the yellow wires of the harness should
connect with the +12V input (Red) of the lights.
STEP 6: Connect the switch to the wiring harness. The
wiring harness red wire is +12V constant, and the wiring
harness yellow wire is the output feeding the lights.
STEP 7: Connect the wiring harness to the battery.
Connect the positive (red) lead first and the negative
(black) lead second. Reconnect the negative terminal of the
battery.
STEP 8: Install the fuse into the wiring harness.