Trail Tech 100 WATT HIGH OUTPUT DC ELECTRICAL SYSTEM KIT FOR FOUR STROKE KTMS WITHOUT ELECTRIC START SR-8310A - Manual

KTM & HUSABERG PLUG AND PLAY
DC ELECTRICAL SYSTEM KIT
SUMMARY & BENEFITS:
• This installation is applicable to Trail Tech HID headlight installation, as well as general DC conversions.
• Install Stator (and flywheel) before completing these wiring instructions
• The reg/rec has two new wires, one to bypass the AC stator connection to the stock wiring harness, the other to provide the
wiring harness with switched DC power.
• If also installing a battery and/or wiring harness, please install those products before starting these instructions!
BENEFITS:
• No cutting or splicing required. Makes a clean installation using factory KTM connectors.
• The installation is completely reversible.
• The stock push-pull lightswitch can be used to turn the lights on and off. Optionaly use the switched relay function for motor on
operation of your lighting accessories
PARTS:
INSTALLATION:
STEP 1:
1A. Remove the fuse (located under the seat, near the battery.)
1B. Locate the stock Reg/Rec underneath fuel tank.
1C. Disconnect the 4-pin connector.
1D. Remove the 8mm bolt holding the stock Reg/Rec.
1E. Remove stock Reg/Rec from machine.
STEP 2:
Install regulator/rectifier using stock 8mm bolt, oposite the
removal process.
Continued on other side >>
010-ELV-44
KTM/Husaberg Rec/Rec
Tech Support: 360-687-4530
[email protected]
REGULATOR/RECTIFIER RELOCATION BRACKET
Fig. 1
STOCK REGULATOR/RECTIFIER INSTALLED
REMOVE BOLT
TO UNINSTALL
STOCK
REG/REC
Fig. 3
TRAIL TECH REG/REC INSTALLED (2000-2011 MODELS)
Fig. 4
REGULATOR/RECTIFIER
Fig. 2