Trail Tech KICKSTAND 5203-00 - Manual

010-ELV-137
TRAIL TECH KICKSTANDS
Tech Support: 360-687-4530
[email protected]
5203-00/5203-10 KICKSTAND INSTALLATIoN
‘06-’09 YZ 250F/450F AND 07-09 WRF 250/450
5203-PK CoNTENTS:
YAMAHA YZ 250F/450F ‘06-’09
YAmAHA INSTALLATIoN:
LIMITED WARRANTY
Trail Tech inc. warranTS Trail Tech KicKSTanD proDucTS To be free from DefecTS in maTerial anD worKmanShip unDer normal uSe anD if properly
inSTalleD for a perioD of Six monThS from DaTe of purchaSe. if founD To be DefecTive aS menTioneD above, iT will be replaceD or repaireD. ThiS Shall
conSTiTuTe The Sole remeDy of The purchaSer anD The Sole liabiliTy of Trail Tech inc. To The exTenT permiTTeD by law, The foregoing iS excluSive
anD in lieu of all oTher warranTieS or repreSenTaTionS wheTher expreSSeD or implieD, incluDeD any limiTeD warranTy of merchanTabiliTy or fiTneSS.
in no evenT Shall Trail Tech inc. be liable for Special or conSequenTial DamageS.
ImPoRTANT: WEAR EYE PRoTECTIoN WHEN HANGING SPRINGS!
Note: After every ride it is important to check your kickstand thoroughly for the following:
• Loose or damaged bolts • Bent or damaged kickstand leg or bracket • Damaged spring
Damaged or broken parts can result in serious injury! If any part of your stand has become
damaged do not ride the machine! Contact a factory trained technician or Trail Tech directly for service or repairs.
5203-PK Parts Kit
A. 5905-04 Kickstand Spring
B. 5903-00 Hanger Tab
1. Remove stock foot-peg, foot-peg
hardware, & foot-peg hanger from frame.
2. Install provided Trail Tech foot-peg
bracket, using the OEM fasteners.
Note: Use thread locking compound
and manufacturers torque specification
during installation.
3. Re install foot peg & foot-peg hardware
following manufacturers recommended
installation procedure.
4. Remove the stock side panel fastener
and insert through the provided spring
hanger tab (Fig. 1)
5. Re-install the side panel fastener, and
tighten down hand tight to start.
Note: Do not tighten down to
manufacturers torque specification
until spring is hung. Failure to do so
may cause your spring to bind or break
during use!
6. Hook spring into spring hanger
mounting tab shown in (Fig. 2)
7. Using safety glasses & a spring puller
stretch the spring and latch it onto the
stand arm mounting point (Fig. 2)
8. Tighten sub-frame fastener to
manufacturers torque specification.
5203-00 Kickstand Installed
Continued on other side >>
FIG. 1
FIG. 2