Trail Tech TTV SWITCHING TEMPERATURE METER KTM 732-S02 - Manual (Page 2)

010-ELV-163
KTM 690
TTV Upgrade Instructions
Tech Support: 360-687-4530
[email protected]
KTM 690
TTV UPGRADE INSTRUCTIONS
Cut the shroud at the indicated spot to mount the TTV
meter. Cut out the template pictured below and use it
to cut a hole to correct size in specified location. Then
install the TTV meter into the shroud. Install shroud back
on to the bike and install reg/rec back on to the shroud.
Disconnect the OEM thermal switch from the bikes harness and then remove it from the radiator. Make sure to remove
the OEM o-ring. Install the provided red adaptor into the radiator using the included o-ring. Next install new threaded
probe sensor into the red adaptor and then plug the sensor into the mating connector from the TTV. Next install the
included jumper plug into the OEM thermal switch connector coming from the bike harness. Make sure to route the wire
so the air box will not pinch it when installed.
STEP 3
STEP 4
Jumper Plug
17.5mm/.68in
25mm/.98in
38.1mm/1.5in
25.4mm/1in
31.1mm/1.22in
44.8mm/1.76in
23.7mm/.93in
13.6mm/.53in
Panel Cutout
(2-4mm/.07-.15in thick)
Actual Size