Tomei Powered OUTLET COMPONENT EVO.7/8/9 Ver.2 - Manual (Page 7)

2. Detach the front o2 sensor from the removed exhaust fitting (outlet)
and reattach it to the outlet included in this kit.
3. Using a new gasket in between, fit the outlet to the turbo charger.
Ensure that the gasket (exhaust fitting gasket) is a new item.
4. Attach the outlet bracket to the outlet and the vehicle.
Reuse the stock outlet bracket and bolts removed earlier.
(M10-P 1.25-20) in a kit.
[Tightening torque : 36N・m(3.6kgf-m)]
5. Attach the front pipe (Use the bolt and gasket shown in the figure A).
Remove the metal collar from the hanger (Figure A / Part ⑩)
before using it to install the front pipe.
The bolts are not required as the fixings insert directly
into the hanger.
6. Installing the crossmember bar
When installing the crossmember
bar on to the vehicle use the
To the outlet
To the vehicle
Do not use.
7
bar on to the vehicle, use the
included aluminum spacers
and bolts to lower the
crossmember bar.
Also, due to differences in the
products and vehicles, the hanger
may not fit properly with the
body of the car. In such a case,
use a vice or wrench to bend the
hanger to ensure correct fitment.
・Use caution to avoid injury when bending the hanger.
・After completing the above, test drive the vehicle to double check the fitment.
7. Reinstall any other parts that were removed.
8. Reconnect the negative battery terminal.
3．Post-installation checks
1. Check to ensure the Outlet Component does not interfere with surrounding parts
or wires.
2. Start the engine and check for exhaust leaks.
Warning
・Be thorough when performing checks as incorrect fitment can cause parts to become damaged,
malfunction and can even lead to fires.
Aluminum spacer
Flange Bolt
[Tightening torque：49Ｎ・ｍ（4.9kgf-m）]
Crossmember Bar
malfunction and can even lead to fires.
・Exhaust leaks not only reduce performance but can also be a health hazard and should be addressed
immediately.
7