Tomei Powered TURBO OUTLET (DOWN PIPES) - Manual (Page 5)

KIT CONTENTS
Please check that your kit contains the following parts. Quantity is shown in ( ).
REQUIRED TOOLS These are the required tools for the installation.
OUTLET PIPE (1)
OUTLET GASKET
（FRONT PIPE SIDE）(1)
M10 SPRING
WASHER (3)
M10 NUT (3)
BOLT SMOOTH PASET (1)
OUTLET GASKET
(TURBO SIDE) (1)
M10 STUD BOLT (3)
L=35mm
O2 ADAPTER (1)
STICKER (2)
・GENERAL ENGINE MAINTENANCE TOOLS ・TORQUE WRENCH
CAUTION
■ These products are designed to be used for off road competition purposes only.
■ This product is designed to be used for off road competition purposes. This product may not
road legal in your country so please check with your local authorities prior to use on general
be public roads.
■ This product is to be installed by a qualified professional in a fully equipped workshop.
■ Refer to the official workshop service manual for details on installation.
■ This product was designed specifically for the engine specified. If the attempt was made to
use this products on another engine other than specified then you will risk of damaging the
related parts in this kit and/or the engine that it is used with.
■ Do the installation when the engine is cold, to avoid risks of burns when the engine is hot.
■ When installing or removing the product please do not use unnecessary brute force as you
may damage the product or related components.
■ Disconnect the negative battery terminal and remove the key from the ignition before attempting
the install.
WARNING
■ This product should be installed on the car when the engine and engine bay is cold.
■ There is a high potential fire hazard risk if not all the correct parts and components
are fitted correctly. Double check everything when the job has been completed before starting
the engine.
5