Tomei Powered 4 THROTTLE SYSTEM - Manual (Page 7)

CAUTION
■ This product is designed for competition used ONLY. Not to be used on public roads.
■ This product will change the safety characteristics of the car and should not be used on public roads.
Doing so may break your local laws.
■ This product is to be fitted with the correct tools, protective & safety equipment. Failure to do so can lead
to possible work hazards.
■ This product is to be fitted by an experienced professional in a fully equipped workshop.
■ Refer to the vehicles original workshop service manual when disassembling the engine.
■ This product was specifically designed to be application specific. This is not a universal product.
If installed on any other vehicles/engines, this product may sustain damage and/or cause engine failure.
■ This product is to be installed when the engine is cold to prevent risk of burns.
■ Do not use excessive force when removing and installing parts. As this may cause damage to the parts
and related components.
■ Always remove the key from the cars ignition and have the negative terminal of the battery disconnected
before working on the car.
REQUIRED TOOLS
These tools are the bare minimum required for the job.
・General Engine Maintenance Tools ・Workshop Service Manual ・Voltage Tester ・Synchro Meter
・Engine Coolant
KIT CONTENTS Below is the contents of this kit with the quantity listed in brackets ().
・Throttle Body
7
・Velocity Stacks
・Intake Manifold
・Fuel Rail
・Fuel Hose
CAUTION
■ You will need to set the correct ignition timing with the stock intake plenum before you install this
product. If the initial ignition timing is changed (especially after changing the camshafts), fire may
come out through the velocity stacks when you start the engine, after installation.
■ You will lose the AAC valve and automatic idle speed adjustment function when installing this product.
You will need to use an aftermarket ECU (like our Reytec for example) to use this product.
■ You will not be able to maintain the required negative pressure supply to the brake booster with the use
of this product. You will need to use a seperate vacuum tank (sold separately and also available from
Tomei; Part Number 193055), if you want to keep the negative pressure for your brake booster.
The brakes will not work properly if there is no negative pressure.
■ Have an oil catch tank and air filter ready (Sold separately; Part number 193077).
7