Tomei Powered FJ MAIN BOLTS - Manual (Page 5)

CAUTION!
■ This product has been designed for competition use only and is not to be used on any public roads.
■ This product is designed for competition use so it must be installed by an experienced qualified
professional with the correct equipment in an appropriate equipped workshop.
■ This product was designed specifically for the engine specified. If the attempt was made to use this
product(s) on another engine other than specified then you will risk of damaging the related parts in
this kit and/or the engine that it is used with.
■ These products were designed for high power output, higher loads and high RPM competition use. So
please note that performance gains still always requires meticulous planning and precision
adjustments on each and every engine. The correct tools and equipment must be used when
assembling the engine and for installation.
■ If the incorrect tools are used then you risk possible injury or damage to the equipment, product(s)
hazards and or vehicle. Please always work in a safe environment to avoid any health and/or safety.
KIT CONTENTS
Below are the parts included in this kit with the quantity no. in brackets ().
REQUIRED TOOLS
The following tools are recommended for the installation process.
* General Maintenance Tools. * M10 x P1.25 Tap
* Engine Maintenance Tools (Torque Wrench etc.) * Thread Tapping Compound
* Manufacturers Service Manual
5
INSTALLATION PROCEDURE
M10 Bolt Seal Washer (x6) M10 Bolt Long (x2)
M10 Bolt Short (x2) M8 Bolt Long
(x1) M8 Bolt Short
(x6)
M10 Washer (x4)
M8 Washer (x7)
・ ARP Molybdenum