Tomei Powered FJ HEAD STUD BOLTS - Manual (Page 5)

CAUTION!
■ This product was designed for competition use ONLY and is for off road use only.
■This kit is to be installed by an experienced professional ONLY as it is specifically designed for
competition use only.
■ This product was designed specifically for the engine specified. If the attempt was made to use this
product(s) on another engine other than specified then you will risk of damaging the related parts in
this kit and/or the engine that it is used with.
■ These products were designed for high power output, higher loads and high RPM competition use.
So please note that performance gains still always requires meticulous planning and precision
adjustments on each and every engine.
The correct tools and equipment must be used when assembling the engine and for installation.
■ If the incorrect tools are used then you risk possible injury or damage to the equipment, product(s)
hazards and or vehicle. Please always work in a safe environment to avoid any health and/or safety.
KIT CONTENTS
Please check that your kit contains the following parts.
REQUIRED TOOLS
These are the required tools for the installation.
* General Maintenance Tools. * Thread Lock Paste
* Engine Maintenance Tools (Torque Wrench etc.) * M11 x P1.25 Tap
* Manufacturers Service Manual * Tap handle, Tapping paste
ASSEMBLY CONFIGURATION
* Assemble both the Left and Right Bank in the same process.
5
Stud Bolt (x12)
Washer (x12) Nut (x12)
Assembly Nuts (x4) * ARP Molybdenum Grease (x1)
Washer(×６）
Nut(×６）
Stud Bolt(×６）
Washer(×６）
Stud Bolt(×６）
Left Bank
Right Bank