Tomei Powered 4G63-22 KIT - Manual (Page 5)

- 5 -
Kit Contents
The Kit includes the following contents.
・Forged Piston x4
・Conrod Bearing x4（ pre-fitted）
・Forged H-Beam Conrods x4
・Bearing selection list x1
・Forged Fullcounter Crankshaft x1
・Front Case Cap Block x1
・Balancer Shaft cap Front (Large) x1
・Balancer Shaft cap Rear (Small) x1
・Molybdenum Greese x1
x1 ・Emblem
x2 ・Sticker
* These are the specialised tools required for the job.
Required Tools
CAUTION
■ This kit has been designed for off road use only.
■ This kit is to be installed by an experienced professional ONLY as it is specifically designed for
competition use only.
■ The correct tools and equipement must be used when assembling the engine and for installation.
If the incorrect tools are used then you risk possible injury or damage to the equipment, product(s)
and or vehicle.
Please always work in a safe environment to avoid any health and/or safety hazards.
■ Please have a copy of the Mitsubishi Motors maintenance manual prepared for reference when
needed.
■ This kit was designed specifically for the engine specified. If the attempt was made to use these
product(s) on another engine that is non specified you will risk the chance of damaging the related
parts in this kit and/or the engine that it is used with.
■ These products were designed for high power output, higher loads and high RPM competition use.
So please note that performance gains still always requires meticulous planning and precision
adjustments on each and every engine.
■ Please ensure that there is adequate engine oil, coolant and fluids prior to starting the engine.
■ When using this kit, the applied vehicle will require upgrading the suspension and brakes to ensure
the overall handling balance and safety of the car.
Balancer Shaft Bearing Remover
Mitsubishi Genuine Parts: Mitsubishi Genuine Parts:
MD998371 MD998372
Silent Shaft Bearing Installer stopper
Mitsubishi Genuine Parts:
MB991603
Balancer Shaft Bearing Installer
Mitsubishi Genuine Parts:
MD998705