Scilogex DM1424 Hematocrit-Centrifuge - Manual (Page 11)

8
7.5 Symmetrically load centrifuge tubes into rotor
CAUTION
z Make sure the rotor lid is securely fixed on the rotor, as well as the rotor and shaft are tightened.
Otherwise, the rotor may be moved off while rotating and cause damage to the centrifuge and rotor.
z Firmly tighten the rotor lid to the rotor.
8. Operation
8.1 Normal operation
Turn on the power switch, centrifuge will start self-diagnostic checks, see figure 8-1 below:
Figure 8-1 Self-checking interface
After self-diagnostics, the centrifuge will display the accumulative running time, see figure 8-2 below:
Figure 8-2 Accumulative running time interface
CAUTION
z Do not push or lean against the centrifuge while it is running.
z Do not run the centrifuge when fragments or sample solutions are left in the centrifuge chamber.
Always keep the centrifugal chamber clean.
z If the centrifuge makes strange noise during operation, stop it immediately and contact our service
center. Notify them of the warning code if displayed.
HELLO 88
℃
88
min
00312 56 45